In the Part 6 of the configuring NSX-T series, we saw how to configure Tier-1 router and get connectivity between vm's from different network. In this blog post, we will see how to configure Tier-0 router so that we get gateway service between the logical and physical network. Create Uplink Segment : To begin with... Continue Reading →
Logging into the NSX-T Manager gives error “Some of appliance components is not functioning”
Recently, while I was working in my lab environment, I faced an issue with my NSX-T deployment it was not allowing me to log in to it. The error message did not help me much to understand the root cause of the issue. I am documenting it here in this blog just in case if... Continue Reading →
Configuring NSX-T Data Center 2.4.0 : Part 6 – Tier-1 Gateway
In my last blog-post, we saw how to deploy and configure NSX-T EDGE nodes. Now, we will start with configuring Logical routing for layer 3 network connectivity. In this blog post, we will configure Tier 1 gateway and test the east west network connectivity between vms from different subnets. Deploy Tier-1 Gateway : A tier-1... Continue Reading →
Configuring NSX-T Data Center 2.4.0 : Part 5 – Deploy Edge Node
In the previous blog post, we discussed about how to get the logical segments configured on the NSX-T environment. If you have missed that please review it here. In this blog post, we will discuss about how to configure the EDGE node. NSX-T EDGE : NSX Edge nodes are appliances with pools of capacity, dedicated... Continue Reading →
How to cleanup an orphaned ESXi host that is NSX-T prepared
In my last blog, we saw how to re-register a vCenter server with NSX-T after the NSX-T is redeployed. In this blog post we will see how to cleanup an Orphaned ESXi host which is NSX-T configured. If we have the NSX-T manager available, we can easily get it done by going to System >... Continue Reading →
Re-registering vCenter server with NSX-T after the NSX-T manager re-deployed
Recently, I had to redeploy the NSX-T manager node due to some issue in the lab environment. After re-deploying the new NSX-T manager 2.4.0, I noticed that the compute manager (vCenter) was not getting registered properly. I was using the old vCenter server itself which was already registered once with the OLD NSX-T manager. In... Continue Reading →
How to install Operations Manager v.2.6
VMware Enterprise PKS 1.5 comes with Operations Manager (OpsMan) version 2.6.8 The deployment of the Operations manager 2.6.8 is different from its earlier versions. In this blog post, we will see how to install Operations Manager 2.6. In the older versions, we installed it using username and password. However, it is a little different from... Continue Reading →
Kontainers 